3 battery initialization – Lenovo 3000 Series User Manual

Page 23

Advertising
background image

Lenovo Notebook Computer User Guide

indicator located in front of the computer. 

 

Hint: No matter whether the battery is installed in the   
computer or not, it always performs self‐discharge. (About 
1% a day) 

If  the  battery  has  not  been  used  for  a  long  time,  it  might  have  no 
power  because  of  self‐discharge.  This  is  the  inherent  feature  of 
lithium‐ion  battery.  You  should  use  the  external  power  source  or 
recharge the battery.   
If  you  still  cannot  turn  on  the  computer  (the  battery  indicator  also 
doesn’t flash), it means the battery is in self‐protection state. Charge 
the  battery  for  2~4  hours  to  activate  the  battery.  Turn  on  the 
computer again when the battery indicator flashes. 

 

Hint: If you do not plan on using the computer for a long   
time, remove the battery pack and store it separately. 

  Note: Charge and discharge the battery at least once every 

three months to avoid the battery malfunctions by   
over‐discharge. 

1.3.3    Battery initialization 

After using the battery for a long time, the battery’s operating time 
is much shorter than the first use. The reason is that the lithium‐ion 
battery  memory  is  affected.  Complete  the  battery  initialization 
process to erase the affected part of the battery memory.   
The battery initialization is the process of fully‐charging the battery, 
fully‐discharging  the  battery  and  fully‐charging  it  again.  Complete 
the following steps to perform the battery initialization process: 
¾ Make  sure  the  computer  has  been  turned  off;  connect  the 

computer to an external power source to charge the battery. 

23

¾ Turn on the computer when the battery is fully‐charged. Press 

Advertising