Liebert EM - Manual (Page 41)

Getting Started With the Web Interface
35
5.7.2 SNMP Information
To access the SNMP Information window, log in (see 5.1 - Open the Web Interface and Log In)
and:
• Click on the Sys Info tab at the top of the Web interface, as shown below.
• Click on the SNMP Information link on the left side of the window. The right side of the window
displays setup information for SNMP traps, as shown above.
• The System information boxes allow you to enter data that will be sent along with SNMP traps to
help easily identify the source:
• If desired, enter the name of a person to contact in the System Contact box.
• The OpenComms EM model name appears in the System Name box—for example, EM PDU
Controller. Enter a different name if desired.
• If desired, enter a description of the unit’s location in the System Location box.
• In the MIB Access box, specify the type of access to the unit’s MIB for your Network Management
System (NMS): One option is Read-Only; the other is Per Community Name, which permits
user-defined access based on entries in the following two boxes:
• Read-Write Community Name - Enter the community string that will allow a user to read
the status of the unit and enter values to configure the unit.
• Read-Only Community Name - Enter the community string that will allow a user to read
the status of the unit.
• Click on the Apply button to keep your changes. (Or click Reset to cancel the changes.)
Sys Info tab
MIB boxes
SNMP
Information
link
System
information