Lenovo 5393 - Manual (Page 42)

9. Align the pivot pin on the hard disk drive cage with the slot 1 in the upper
drive cage, as shown in Figure 24. Then, slide the drive cage with the new
hard disk drive into the chassis.
10. Connect the signal cable and the power cable to the rear of the new hard disk
drive. See “Connecting a SATA drive” on page 31.
11. Press down on the metal latch 2 and pivot the drive cage into place. Then,
slide the drive cage to the front of the computer until it snaps into position.
Note: There are two arrows, one on the hard disk drive cage and one on the
upper drive cage. The arrows are aligned when the hard disk drive
cage is in the proper position.
Figure 24. Installing the primary hard disk drive
34 User Guide