Lenovo 5393 - Manual (Page 44)

5. Press the blue release button 1 to release the hard disk drive cage from the
chassis. Then, lift the hard disk drive cage and completely remove it out of
the chassis.
6. Carefully pull on the blue handle to slide the hard disk drive out of the drive
cage.
7. Flex the sides of the blue bracket properly to remove the hard disk drive from
the bracket.
8. To install a new hard disk drive into the blue bracket, flex the sides of the
bracket properly and align pin 1 , pin 2 , pin 3 , and pin 4 on the
bracket with the corresponding holes in the hard disk drive. Do not touch the
circuit board 5 on the bottom of the hard disk drive.
9. Slide the new hard disk drive with the bracket into the drive cage until it
snaps into position.
Figure 25. Removing the secondary hard disk drive
Figure 26. Installing the hard disk drive into the bracket
36 User Guide