Replacing the primary hard disk drive – Lenovo 5393 User Manual
Page 40
2.
Locate an available five-wire power connector and connect it to the SATA drive.
Replacing the primary hard disk drive
Attention
Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
This section provides instructions on how to replace the primary hard disk drive.
To replace the primary hard disk drive, do the following:
1.
Remove all media from the drives and turn off all attached devices and the
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
2.
Remove the computer cover. See “Removing the computer cover” on page 16.
3.
Locate the primary hard disk drive. See “Locating internal drives” on page 12.
4.
Disconnect the signal cable and the power cable from the rear of the primary
hard disk drive.
Figure 20. Connecting a SATA optical drive
Figure 21. Connecting a SATA hard disk drive
32
User Guide