Lexmark X500N - Manual (Page 92)

Menu item Description
PBX Access Digit
xxx
Specifies an outside line dispatch number
Notes:
• 9 is the factory default setting.
• Any number from 1–999 can be used.
Default Mode
Copy
Fax
Specifies whether the printer will be in Fax mode or Copy
mode following either of these two events:
• The printer is turned on.
• The Auto Clear setting times out.
Note: Copy is the factory default setting.
Auto Clear
Off
On
30 sec
1 min.
2 min.
3 min.
5 min.
10 min.
Sets whether the printer automatically returns to the Default
Mode setting after the set amount of time if no operation is
done during that time
Notes:
• On (30 sec) is the factory default setting.
• Off disables the Auto Clear function.
Power Saver
Off
On
Wait 1–240min
Sets the amount of time in minutes the printer waits after a job
is printed before it goes into a reduced power state
Notes:
• On (30 min.) is the factory default setting.
• Lower settings conserve more energy, but may require
longer warm-up times.
• Select the lowest setting if the printer shares an electrical
circuit with room lighting or you notice lights flickering in
the room.
• Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm-up time.
Display Language
ENGLISH
FRENCH
GERMAN
ITALIAN
SPANISH
Selects the language of the text appearing on the display
Country Code
<list of country codes>
Sets the country or region where the printer is being used
Note: The Country Code must be set correctly for the fax
function to work properly.
92