Lexmark X500N - Manual (Page 95)

Cover Open: Close OPC Cover
The door (OPC Cover) under the scanner unit is open. Close the OPC door to clear the message.
Cover Open: Close Rear Cover
Close the rear door to clear the message.
Communication Error
A network communication error has occurred. Check network settings and connections.
Dial Fail
The printer attempted to dial the fax number and send the fax several times but could not connect with the destination
fax machine. Try sending the fax again.
Dialing
The printer is dialing a fax number. Wait for the message to clear.
Duplicate IP: Duplicate IP Address Found
The IP address has been duplicated.
Disconnect the LAN cable, change the IP address using the Network Settings menu, and then reconnect the LAN
cable.
Email Size Over: Email Size Limit Exceeded
The scan job is too large to send. Increase the Limitation Of Size Of Mail setting, and then scan the job again. If the
message occurs again, lower the scan resolution to decrease the job size.
Fail to Connect to Server: Server Connection Failed
A network communication error has occurred. Check network settings and connections.
Fuser Life: Replace Fuser
1 Replace the fuser unit.
2 From the Machine Settings menu, reset the fuser counter.
Incoming Call
The printer is preparing to answer a fax call. Wait for the message to clear.
Initializing
Initial diagnostics are running. Wait for the message to clear.
Job #
The scanner is busy. Wait for the message to clear.
Memory Full
There is insufficient memory to complete the current copy job. Cancel the job, and then try copying it again.
Memory Near Full
There may be insufficient memory to complete the current print job. If the job fails to print, cancel the job, and then
try sending it again.
95