Replacing the front panel board – Lenovo RD430 User Manual
Page 175
10. Position the new riser card assembly 2 on the chassis and align it with the riser card assembly 2 slot on
the system board and align the rear of it with the corresponding rail guides in the rear of the chassis.
Then, carefully press the new riser card assembly 2 straight down into the chassis until it is fully seated.
Note: If there is any PCI Express card installed on the riser card assembly 2, carefully fit the PCI Express
card into the chassis and properly route any cables from the card.
Figure 122. Installing the riser card assembly 2
11. If you are instructed to return the old riser card assembly 2, follow all packaging instructions and use
any packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to “Completing the parts replacement” on page 174.
Replacing the front panel board
This topic provides instructions on how to replace the front panel board. This topic contains the following
items:
•
•
“Replacing the front panel board for server models with 2.5-inch hard disk drive bays” on page 165
For server models with 12 3.5-inch hard disk drive bays, the front USB connectors are integrated into the left
rack handle; and the front controls and LEDs are integrated into the right rack handle. See “Front view of
server models with 12 3.5-inch hard disk drive bays” on page 17 for detailed information.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Chapter 6
.
Installing, removing, or replacing hardware
163