Lenovo RD430 - Manual (Page 33)

4 Slim optical drive
Some server models come with a slim SATA optical drive.
5 Rack handle (left)
8 Rack handle (right)
If your server is installed in a rack cabinet, you can use the rack handles to help you slide the server out
of the rack cabinet; or use the rack handles and screws to secure the server in the rack cabinet so that
the server cannot slide out, especially in vibration-prone areas. For more information, refer to the Rack
Installation Instructions that comes with your server.
6 Diagnostic panel
The diagnostic panel varies by model. For detailed information, see “Diagnostic module” on page 23.
7 Front panel
For detailed information about the controls, connectors, and status LEDs on the front panel, see “Front
panel” on page 21.
Front panel
This topic applies only to the following server models:
• Server models with eight 3.5-inch hard disk drive bays
• Server models with 2.5-inch hard disk drive bays
For server models with 12 3.5-inch hard disk drive bays, the front USB connectors are integrated into the left
rack handle; and the front controls and LEDs are integrated into the right rack handle. See “Front view of
server models with 12 3.5-inch hard disk drive bays” on page 17 for detailed information.
The following illustration shows the controls, connectors, and LEDs on the front panel of the server. To locate
the front panel, see “Front view of server models with eight 3.5-inch hard disk drive bays” on page 16 and
“Front view of server models with 2.5-inch hard disk drive bays” on page 20.
ID
Figure 11. Front panel
1 Power switch with power status LED 5 System error LED
2 ID button with ID LED 6 Front USB connectors (2)
3 NIC 1 status LED 7 VGA DB-15 connector
4 NIC 2 status LED
Chapter 3 . Product overview 21