Lexmark 4800 - Manual (Page 92)

5 Press .
If there is more than one computer connected to the network, you will be asked to select the computer that
you want to use.
a Press or to select a computer.
b Press .
If you set a PIN during network setup and are being asked for it:
1 Enter the PIN using the and to select a digit location and the and to select a value for
that digit.
2 Press .
c Press to begin saving photos to the computer.
The Network Card Reader dialog appears on the computer screen.
To adjust the settings of the Network Card Reader:
1 Choose Lexmark Network Card Reader ΠPreferences.
2 If necessary, click General.
3 Choose whether to show a notification dialog when a memory device is inserted into the printer.
4 Click Settings.
5 Assign a name to your computer.
6 Choose whether to specify a PIN to be able to access your computer.
Note: The PIN should be a combination of four digits from 1–9.
7 Click Apply.
These buttons are at the bottom of the Network Card Reader dialog:
Click To
+ Add a network printer to the list.
– Remove a network printer from the list.
Connect to a network printer on the list.
Understanding the printer
92