LevelOne WBR-6000 - Manual (Page 38)

N_One Wireless Broadband Router
Wireless Station Configuration
This section applies to all Wireless stations wishing to use the Wireless Broadband
Router's Access Point, regardless of the operating system which is used on the client.
To use the Wireless Access Point in the Wireless Broadband Router, each Wireless
Station must have compatible settings, as follows:
Mode The mode must be set to Infrastructure (rather than Ad-hoc)
Access points only operate in Infrastructure mode.
SSID (ESSID) This must match the value used on the Wireless Broadband
Router. The default value is WBR-6000.
Wireless
Security By default, Wireless security on the Wireless Broadband Router is
disabled.
• If Wireless security remains disabled on the Wireless Broad-
band Router, all stations must have wireless security
disabled.
• If Wireless security is enabled on the Wireless Router (either
WEP or WPA-PSK), each station must use the same settings
as the Wireless Broadband Router.
37