LevelOne WBR-6000 - Manual (Page 40)

N_One Wireless Broadband Router
Data - Status Screen
Internet
Connection Method Displays the current connection method, as set in the Setup
Wizard.
Connection Status This indicates the current status of the Internet Connection
• Active - Connection exists
• Idle - No current connection, but no error has been
detected. This condition normally arises when an idle
connection is automatically terminated.
• Failed - The connection was terminated abnormally.
This could be caused by Modem failure or the loss of
the connection to the ISP's server.
If there is an error, you can click the "Connection Details"
button to find out more information.
Internet IP Address This IP Address is allocated by the ISP (Internet Service
Provider). If using a dynamic IP address and no connection
currently exists, this information is unavailable.
Connection Details Click this button to open a sub-window and view a detailed
description of the current connection. Depending on the
type of connection, a "log" may also be available.
LAN
IP Address The IP Address of the Wireless Broadband Router.
Network Mask The Network Mask (Subnet Mask) for the IP Address
above.
DHCP Server This shows the status of the DHCP Server function. The
value will be "Enabled" or "Disabled".
MAC Address This shows the MAC Address for the Wireless Broadband
Router, as seen on the LAN interface.
Wireless
Name (SSID) If using an ESS (Extended Service Set, with multiple ac-
cess points) this ID is called an ESSID (Extended Service
Set Identifier).
Region The current region, as set on the Wireless screen.
Channel This shows the Channel currently used, as set on the
Wireless screen.
Wireless AP This indicates whether or not the Wireless Access Point
feature is enabled.
Broadcast Name This indicates whether or not the SSID is Broadcast. This
setting is on the Wireless screen.
System
Device Name The current name of the Router.
Firmware Version The version of the current firmware installed.
39