LEICA 2 - Manual (Page 20)

20 Getting started with new equipment GPS Equipment User Manual -2.0.0en
Measuring with the default configuration parameters, continued
The screen is altered as follows:
The STORE key has become active,
and you still have the chance to
check and correct the entered point
id and the antenna height.
Conclude the survey sequence by
again pressing F1 STORE.
After pressing the STORE key all
related information will be stored in
the currently used job (point id,
antenna heights, etc.)
Step 6: Ending a Survey
You can now quit the survey opera-
tion panel by pressing SHIFT F6
QUIT. This brings you back to the
main menu.
Hint: Pressing SHIFT F6 will always
allow you to terminate the survey
operation, even during a site occupa-
tion. In this case you will loose all
data collected since pressing
OCUPY.
As soon as you are back to the main
menu the PC-card may be removed.
This is indicated by the PC-card icon
in the status line which contains an
arrow:
Datalogging should continue depend-
ing on your observation plan: a
receiver used as reference has to run
permanently until all rover site occu-
pations are completed. If a unit is
operated as a roving receiver the site
occupation time depends mainly on
the baseline length and your accu-
racy requirements. See
General
Guide to Static and Rapid Static for
details.
Once sufficient amount of raw data
has been collected the survey of the
point can be completed by pressing
F1 STOP.