Liebert UPStation GXT - Manual (Page 5)

1
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE
INSTRUCTIONS
This manual contains important instructions that
should be closely followed during installation and
maintenance of this UPStation GXT 6kVA
Maintenance Bypass.
This product is designed for commercial / industrial
use only. This product is not intended for use with
life support and other designated “critical” devices.
Maximum load must not exceed that shown on the
Maintenance Bypass Cabinet rating label.
The UPStation GXT 6 kVA Maintenance Bypass is
designed for use on properly grounded (earthed)
208/240VAC 60Hz supply, for installation by
qualified personnel. This UPS equipment is
intended to be installed by a qualified / certified
electrician who must review and approve customer
supplied wiring, circuit breakers, intended loads
and verify correct input, output and grounded
(earth) connections to ensure compliance with
technical standards and national and local
electrical codes. Installation instructions and
warning notices are in the Cable Installation
section of this manual beginning on page 6.
Install the bypass equipment in a clean
environment, free of conductive contaminants,
moisture, flammable liquids, gases, and corrosive
substances.
!
WARNING
LETHAL VOLTAGES MAY BE
PRESENT WITHIN THIS UNIT
EVEN WHEN IT IS APPARENTLY
NOT OPERATING. OBSERVE ALL
CAUTIONS AND WARNINGS IN
THIS MANUAL. FAILURE TO DO
SO MAY RESULT IN SERIOUS
INJURY OR DEATH. NEVER
WORK ALONE.
!
CAUTION
To reduce the risks of fire, connect
only to a circuit provided with
maximum branch circuit
overcurrent protection of 40A in
accordance with applicable
national and local electrical codes.