Logic 3 V5.00 - Manual (Page 56)

3xLogic Vigil System Server Software - User’s Guide Doc# 08100610 Page 56
2.1.3 Advanced Settings
In the “Advanced Settings” window, the cameras are grouped into “Bank” tabs that represent the physical
camera banks in the DVR. This allows the user to maximize the capture resolution and recording speeds for
each camera bank. When the number of FPS is changed in the “Advanced Settings” window, it is applied to
all recording modes.
Camera Drop-
down
Select a camera number within the selected bank tab.
Capture
Resolution
Select the desired recording resolution from the drop-down list.
Recording
Speed
Use the dropdown list to select the desired number of frames per second. Each bank has
a set amount of FPS that can be set its cameras. Values will change depending on the
other recording speeds for the other cameras within the same bank.
Network
Camera
Designates the selected camera as a network camera and will disable the camera feed.
Network camera speeds are independent of other cameras and do not change the total
amount of FPS in a camera bank.
Note:
The number of banks and the cameras in each bank is determined by the capture card
installed and cannot be configured. There are many possible different layouts of banks and channels
per bank.
Push Still Shot to Server 2.1.4
The “Push Still Shot to Server” settings allow a still shot from the camera to be copied periodically to another
location. To enable this feature for the selected camera, check the “Enabled” box. Click the “Settings…”
button to configure the destination for the still shots.