Connect the usb port replicator for the monitor, Using the audio connectors, Chapter 4. working with – Lenovo L2230x User Manual

Page 26: L2230x wide usb port replicator monitor -1, Service information

Advertising
background image

Chapter 4. Working with

L2230x Wide USB Port Replicator Monitor

Connect the USB Port Replicator for the monitor

1. Be sure to install the USB Port Replicator driver for L2230x Wide

USB Port Replicator

monitor on your computer. The driver name is “Usb_PR_Setup.exe".

2. Plug L2230x Wide USB Port Replicator monitor power cord, and power on L2230x Wide

USB Port Replicator Monitor.

3. Connect the USB B plug of the USB cable to the USB B receptacle connector on

L2230x Wide USB Port Replicator monitor.

4. Connect the USB A plug of the USB cable to an available USB connector on the computer.

The system will automatically identify and configure the port replicator for

L2230x Wide

USB Port Replicator monitor.

Then y

ou can connect devices to the

appropriate

connectors on the monitor. Normally it will take some time for the computer to recognize

the new device.

Note: The settings you have configured for the port replicator will be

retained each

time you connect the computer to the port replicator. This

feature is useful when you

use your computer with multiple port

replicators. For example, if you use a computer

both at home and at work, you can set up both work areas with port replicators. Then,
you just

connect your computer to the port replicator at either location, and you are

ready to work.

Using the audio connectors

The audio connectors on L2230x Wide

USB Port Replicator monitor consists of one

microphone connector (red) and one headphone connector (green). The audio connectors

are automatically enabled when you have successfully connected the port replicator of L2230x

Wide USB Port Replicator monitor and installed the device driver. However, if you can not

hear anything from the headphones or speakers connected to the audio connectors, you

can manually enable the audio connectors on the port replicator,do the following:
1. Click

L2230x Wide USB Port Replicator Monitor icon in the taskbar notification area.

2. Select Audio. For Windows XP users, the Sound and Audio Devices

Properties

window opens. For Windows Vista and Windows 7 users, the Sound window opens.
3.

Depending on the operating system you are using, do one of the following:

©

©

4-1

Copyright Lenovo 2010.

Advertising