Lexmark 2500 - Manual (Page 64)

Control panel lights Status Action required
Power
Ready
Paper Out
Panel Lock
Font Lock
On
Blinking
Blinking
Blinking
Blinking
1 Check for a paper or ribbon jam.
2 Turn the printer off.
3 Remove the ribbon cartridge, and then check for
paper dust or bits of paper.
4 Make sure the carrier packing tape has been
removed.
5 With the printer on, run the printer test.
a Replace the ribbon cartridge, and make sure
paper is loaded.
b Turn the printer off.
c Press and hold LineFeed while turning the
printer on.
d Release LineFeed when printing starts.
Printing continues until the printer is stopped.
6 If the printer test fails, contact Customer Support.
Note: If the printer is not beeping, there is a power
supply problem. Contact Customer Support.
Power Off Check the power cord and power source. If the power
light remains off, contact Customer Support.
Power
Ready
Paper Out
Panel Lock
On
Off
Blinking
Blinking
The paper select lever has been changed while the
paper was loaded. Move the paper select lever back to
the correct position, and then press Start/Stop.
Note: Make sure the paper is parked or unloaded before
changing the position of the paper select lever.
Power
Ready
Paper Out
Panel Lock
On
Blinking
Blinking
Blinking
1 Open and close the control panel.
2 Turn the printer off and back on.
3 If the control panel light sequence continues,
contact Customer Support.
Power
Ready
Paper Out
Tractor 2
On
Blinking
Blinking
Blinking
Make sure the Tractor 2 option is installed correctly. For
more information, see the documentation that came
with the option.
Troubleshooting
64