Lincoln Series 1100 User Manual

Page 12

Advertising
background image

Impinger II – Digital Advantage Ops Manual –Dom & Int’l

12

GENERAL INFORMATION

The instructions that follow are intended as a guide for preparing for the installation of the Impinger Conveyor Oven.

First and foremost, each crate should be examined before signing the Bill of Lading to report any visible damage by

the trucker in transit, and to account for the proper number of crates.

IF THERE IS APPARENT DAMAGE:

UNITED STATES AND CANADA: Arrangements should be made to file a claim against the carrier. As Interstate

Commerce Regulations require that the claim must be initiated by the consignee.

ALL SHIPMENTS TO OTHER COUNTRIES: Freight terms will be developed and extended on an individual basis.

Proper and secure storage facilities should be arranged for the oven(s) if necessary to protect it from outdoor or

damp conditions at all times before installation.

PACKING AND WEIGHTS

All uncrated components of the Impinger Conveyor Oven will pass through a 30 inch wide door. The Impinger

Conveyor Oven consists of:

Cartons or Crates

Weight of Each

Dimensions of Each

1 – oven (export)

486 lbs. (220.5 Kilo)

43 ½” x 63” x 24” (1104.9 x 1600.2 x 609.6 mm)

1 – oven (domestic)

396 lbs. (180.0 Kilo)

42” x 59” x 23” (1066.8 x 1498.6 x 584.2 mm)

1 – stand (export & domestic)

45 lbs. (20.4 Kilo)

42” x 26 “ x 5” (1066.8 x 660.4 x 127 mm)

UNCRATING

When you have all the crates unloaded, open the crates and remove the plastic covers. Inspect at once for

concealed damage. If anything appears to be damaged, contact the appropriate persons immediately to file a

damaged claim. After completing this inspection, finish unpacking the oven and all other components. Be sure to

remove the packing cardboard from the plenum shroud. Move the components inside near the area where they will

be assembled in the order in which they will be assembled.

ASSEMBLY INSTRUCTION

MODEL 1120, 1121 OVEN STAND

DO NOT OVERTIGHTEN

NUTS AND CRUSH TUBING!

POSITION THE TWO SIDE PIECES SO THAT THE HOLES

FOR THE OVEN MOUNTING ARE AS SHOWN

Advertising