Lincoln Series 1100 - Manual (Page 20)

Impinger II – Digital Advantage Ops Manual –Dom & Int’l 20
PROGRAMMING THE DIGITAL ADVANTAGE 1100 SERIES TOUCH PAD
INTRODUCTION: START-UP AND SHUT DOWN
For the operator, the panel has power-up, run, and program menu modes.
To start the oven, turn the power switch on. To shut down the oven, turn
the power switch off.
FRONT PANEL LAYOUT
The front panel contains four (4) momentary push-buttons: TEMP, TIME,
UP, and DOWN. There is a two-line by sixteen-character VFD display.
TEMPERATURE SETPOINTS
For Digital Advantage ovens there is one setpoint. To enter the setpoint mode, press the TIME & TEMP buttons
together and hold for 5 seconds. Pressing the TEMP push-button, the display will show the current setting.
Pressing the UP or DOWN push-buttons will raise or lower the temperature to the desired setting. In the
Fahrenheit (or F mode) the temperature is adjusted in 1-degree increments. Pressing and holding the UP or
DOWN keys will allow the settings to “roll” at a much faster rate. When the desired temperature is indicated,
release all keys. After 5 seconds the selected setpoints will be stored and remain in memory.
TIME SETPOINTS
There is one set point for the conveyor speed. Enter the setpoint mode as mentioned above. The speed can be
set as follows:
1:00 to 9:55 in 5 second increments
10:00 to 12:45 in 15 second increments
13:00 to 19:30 second increments
20:00 to 30:00 in 1 minute increments
JUMPING BETWEEN MENUS
Pressing the TIME pushbutton while in the TEMP setting mode (and vice versa) will cause the menu selection to
jump over to that mode.
DIAGNOSTIC MESSAGES
The Digital Advantage ovens have diagnostic messages within the control. Upon the unexpected event that there
is a failure in the oven operation, the following messages will appear in the control:
OPEN PROBE
This occurs when there is no temperature being sent to the controller from the baking chamber.
SHORTED PROBE
This occurs when a constant temperature setting signal (as opposed to the normal cyclical cavity temperature) is
being sent to the controller from the baking chamber. CAUTION: This message can occur when there is no gas
supply to the oven. If the oven does not detect a temperature fluctuation in 5 minutes, the error message will
appear. Be sure to check the gas valve and gas hose for proper connections.
BELT JAM
This occurs when the conveyor motor fails.
REVERSING SWITCH
The Digital Advantage 1100 Series has a belt direction reversing switch located on the back of the oven which
allows for right to left or left to right operation.
FUNCTIONS
THERMAL CUT-OUT SWITCH
The Impinger II unit includes a “safety thermal cut-out switch” for your protection. This safety related device is
designed to insure that the Impinger II unit will not overheat and damage the unit. In the unlikely event that the
Impinger II unit would exceed the specified operating temperature range, the “safety thermal cut-out switch” will
activate, thus blocking power to the Impinger I unit and causing it to turn off.
CAUTION:
In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external switching device, such as a
timer or connected to a circuit that is regularly switched on and off by the utility.
!