Lava Computer 650 - Manual (Page 17)

17
Windows NT 4.0 Installation
Windows NT Driver Installation
1. Once the LavaPort-650 is installed in your PC, turn your computer on
and start NT.
2. Place the LavaPort installation diskette into your floppy drive and
select Run from the Start Menu. When prompted type:
A:\NT4.0\Setup.
3. After the necessary files have been copied, select My Computer and
start Control Panel. A new icon will appear called “LavaPort”.This
applet should now be used to configure ALL Com Ports in your PC -
not just LavaPorts.
Note: Make sure that you are installing the correct LavaPort-650
drivers for the appropriate operating system.
DO NOT install Windows 3.x/95/98/Me/2000/XP drivers
under Windows NT