Life Fitness GS2 - Manual (Page 8)

S
TEP
4:
• Insert two GUIDE RODS (16) into the BASE (2) as
shown on FIGURE 4. Note: If the GS2 SHROUD
OPTION was purchased, place the GUIDE RODS
(16) through the BOTTOM SHROUD BRACKET
(FOUND IN THE SHROUD KIT BOX) into the BASE
(2), as shown in FIGURE 4.
Note: Lubricate GUIDE RODS (16) with silicon or
teflon spray available at most hardware stores.
• Slide the following items in order down each GUIDE
ROD (16), one WEIGHT STACK SPACER (45), and
one WEIGHT STACK CUSHION (46)
• Using EXTREME CARE slide all fifteen WEIGHT
PLATES (22) down the GUIDE RODS (16) onto the
WEIGHT STACK CUSHIONS (46). Make sure that the
keyholes of the WEIGHT PLATES (22) are all facing
the right way.
• Slide the head plate assembly down GUIDE RODS
(16) onto the weight stack.
• Slide the following items in order down each GUIDE
ROD (16), one WEIGHT STACK SPACER (45), and
one WEIGHT STACK CUSHION (46)
S
TEP
5:
• Carefully slide the RIGHT (5) and LEFT (4) BOOM PLATES onto the GUIDE RODS (16 )as shown in FIGURE 5 and
loosely assembly BOOM PLATES (5), (4) to frame (1) using two 3/8 x 3-3/4” BOLTS (30) and two 3/8” LOCK NUT (34)
CAUTION MUST BE TAKEN NOT TO PULL GUIDE RODS (16) OUT OF BASE (2)
• Screw ADJUSTABLE GLIDE (53) approximately 1/2” into FRAME (1) and tighten jam nut securely as shown.
8
2
46
16
48
45
HEAD
PLATE
ASSY
GS2 SHROUD
BRACKET
OPTION ONLY
F
IGURE
4
53
34
4
5
30
16
3/8 X 3-3/4
F
IGURE
5