Linksys iPhone CIT400 - Manual (Page 18)

Dual-Mode Internet Telephony Kit
10 Chapter 3: Getting Started
Getting Started with the Base Station
Getting Started with the Base Station
To connect the base station, follow these instructions:
1. If you have a landline, connect a RJ-11 telephone line cord (included) to the LINE port of the base station.
Then connect the other end to your telephone wall jack. If only the landline is connected you can only make
and receive calls over the landline.
2. Connect the Ethernet RJ-45 cable (included) to the Ethernet port of the base station. Then connect the other
end to a network Ethernet jack. If only the Ethernet cable is connected, you can only make and receive
Skype or SkypeIn calls.
3. Connect the included power adapter to the power port of the base station. Then plug the power adapter into
an electrical outlet.
Proceed to the next section, “Powering On the Handset.”
Powering On the Handset
When the handset is fully charged, press and release the Power/End Call key; this will power on the handset. To
power off the handset, press the Power/End Call key until you will see the Skype menu. Scroll to Switch Off.
Press Select and the phone will power off.
• Standby mode is when the phone is on, but not in use. In standby mode your phone displays signal strength,
handset number (in parenthesis), battery charge status, Skype status, user i.d. and time.
Figure 3-3: Connect to the
LINE Port
Figure 3-4: Connect to the
Ethernet Port
Figure 3-5: Connect to the
Power Port