Linksys iPhone CIT400 - Manual (Page 76)

Dual-Mode Internet Telephony Kit
68 Appendix A: Troubleshooting
Common Problems and Solutions
3. When the handset is placed on the charger, I do not hear a beep.
If you have turned off the handset tone (refer to “Chapter 4: Using the Dual-Mode Internet Telephony Kit) or if
the handset was previously powered off, then this is normal, and you were not supposed to hear a beep.
If you were supposed to hear a beep, then do the following:
A. Remove the handset from the charger, and then place it on the charger again.
B. Clean the charging contacts with a clean and dry cloth.
4. The Battery Empty icon is displayed even though the handset has charged for more than 14 hours.
Do the following:
A. Check that the batteries are installed correctly.
B. Make sure the handset is placed properly on the charger.
C. Use new rechargeable batteries.
5. The handset’s display screen is blank.
Do the following:
A. Check to see if the batteries are positioned properly in the battery compartment.
B. Make sure that you have properly connected the handset, charger, and base station. (Refer to “Chapter
3: Getting Started.”)
C. Put the handset on the charger to recharge the batteries.
6. The audio quality is poor.
Do the following:
A. Move the handset closer to the base station.
B. There may be interference from nearby electrical devices. Move the base station as needed.
C. If the base station and handset are in a room with thick walls, move the base station and handset as
needed.