Lindy 32364 - Manual (Page 38)

LINDY Dual/Quad PRO Installation and Use Page 37
3.6.9 AUTOSCAN MODE
Accessed from menu: GLOBAL PREFERENCES
Settings: ACTIVE, ALL
The LINDY Dual/Quad PRO supports an autoscan mode that automatically scans
between the connected computers in sequence. The LINDY Dual/Quad PRO can be
set to scan ALL the available computers or just the available computers that are
currently powered on (the ACTIVE computers). Scanning just the active computers
avoids blank screens from being displayed and stops the monitor from going into a
power down state on every scan cycle.
WARNING - Many modern monitors are fitted with automatic power save relays
and will switch off after a few seconds if connected to an inactive PC. If you
are using such a monitor you must not set the LINDY Dual/Quad PRO to scan
ALL ports. Constant switching on and off of your monitor's relay will
eventually damage your monitor.
3.6.10 AUTOSCAN TIME
Accessed from menu: GLOBAL PREFERENCES
Settings: DISABLED; 2, 5, 7, 10, 15, 20, 30 SECONDS
The autoscan time defines the length of time that the LINDY Dual/Quad PRO will
display video from an autoscanned computer before changing to the next computer.
If the DISABLED setting is chosen then no autoscan functions will be available.
3.6.11 OSD DWELL TIME
Accessed from menu: GLOBAL PREFERENCES
Settings: 1, 2, 3, 5, 10 SECONDS
After a successful computer channel change the LINDY Dual/Quad PRO will display
a confirmation message for a few seconds. The length of time that this confirmation
message dwells on the screen may be changed. Options are 1, 2, 3, 5 and 10
seconds.