Lindy 32364 - Manual (Page 62)

LINDY Dual/Quad PRO Installation and Use Page 61
To perform a flash upgrade on the LINDY Dual/Quad PRO :
Step 1 - Prepare your computers
Ensure that you have saved any important work on the connected computers. The
LINDY Dual/Quad PRO can be upgraded whilst attached to live systems but
remember that the mouse connections will probably need to be reconstituted after
the upgrade is finished (see sections 4.13 and 2.9). Where possible, mission critical
servers should be switched off or disconnected before performing an upgrade.
Step 2 - Connect your computer to the LINDY Dual/Quad PRO
Connect your computer's serial port to the LINDY Dual/Quad PRO 's serial port (see
figure 2).
You do not need to set the serial baud rate and protocol because the
upgrade program will do this for you automatically (for reference, the RS232 baud
rate used by the upgrade program is 19200 and the protocol is 8 bits, 1 stopbit and
no parity).
Step 3 - Select flash upgrade mode using option switch 2 (labelled UPGRADE)
Move option switch 2 on the back of the LINDY Dual/Quad PRO to the ON position
(down).