Lindy 32364 - Manual (Page 57)

LINDY Dual/Quad PRO Installation and Use Page 56
To perform a power-off reset for a selected user port:
1) Press the USER key on the front panel of the LINDY Dual/Quad PRO to select
the user port whose keyboard and mouse you wish to reset.
2) The selected user port number should now be shown on the green USER
display.
3) Press and hold down the USER key for 5 seconds until the green USER display
goes off. The keyboard and mouse will then be powered off.
4) As soon as the green display goes off you may release the USER key. The
green display will then come back on and a few seconds later the keyboard and
mouse will be powered on and ready for use.
4.18 Using the LINDY Junior / Pro Extender
Refer to the installation guide provided with your LINDY Extender. The transmitter
unit (LINDY Extender) is built into the LINDY Dual/Quad PRO so you will only need
the receiver (LINDY Junior Extender unit). You may use a LINDY Junior Extender
receiver or a LINDY Pro Extender receiver.
When using an LINDY extender we highly recommend that you set the LINDY
hotkeys to be different to the LINDY Dual/Quad PRO's hotkeys to avoid any
confusion
4.19 What to do if you forget your ADMIN password
If you forget your ADMIN account password you will not be able to access the
LINDY Dual/Quad PRO to add or edit users and computer names. If this unfortunate
situation does occur then you can resolve it by performing a complete reset to return
the LINDY Dual/Quad PRO to its factory default state. A complete reset erases all
the user names and computer names that you have setup. You can only perform a
complete reset if you have access to both the front and the rear of the LINDY
Dual/Quad PRO.