Linksys PC22604 - Manual (Page 51)

2. Perform one of the following steps:
• To specify a megabit profile that is used by a 10/100 Megabit port, refer to
"Megabit Profile".
• To specify a gigabit profile that is used by a Gigabit port, refer to "Gigabit
Profiles".
Megabit Profile
To select a megabit profile:
1. With Megabit Profile highlighted in the QoS Profile screen, press the
Enter key. The Megabit Profile screen appears.
2. Use the Down Arrow key to highlight a profile, then press the Enter key.
The Megabit Profile Attributes screen appears.
Note
In the Megabit Profile screen:
A1 = active profile #1, which can be used by any 10/100 Megabit port.
A2 = active profile #2, which can be used by any 10/100 Megabit port.
A3 = active profile #3, which can be used by any 10/100 Megabit port.
A4 = active profile #4, which can be used by any 10/100 Megabit port.
NA = indicates a profile that is not active and cannot be used by any 10/100
Megabit port.
93
Layer 2 Management 4-Port Gigabit Ethernet Switch ProConnect II ® Series
2. Press the Down Arrow key to highlight a ToS priority number.
Note:
The ToS priority number is determined by bit [4:2] of the ToS field in the IP
header.
3. Press the Enter key. The ToS Priority Setting screen appears. This screen
is similar to the VLAN Priority Setting screen.
4. Perform steps 3 through 9 under "Specifying the QoS VLAN Priority".
Selecting a QoS Profile
To select a QoS profile:
1. From the QoS screen, use the Down Arrow key to highlight Profile, and
then press the Enter key. The QoS Profile screen appears.
92