Lexmark 4076-0XX - Manual (Page 23)

4076-0XX
Diagnostic Information 11
SIMM Problem
Service Checks
Envelope Feed Service Check
First Print Line Service Check
SYMPTOM ACTION
Can’t write to SIMM Go to the “Simm Service Check” on
page 22 .
FRU OR PROCEDURE ACTION
1 Envelope Loading Be sure the envelope guides have
been turned to the envelope load
positions
Be sure the envelope guides are
against the envelopes
Go to and perform the “Paper Feed
Service Check” on page 14 .
FRU OR PROCEDURE ACTION
1 End-of-Forms Flag Check the flag for binds or damage.
2 End-of-Forms Sensor Check the sensor for dirt.
3 System Board Perform the “Paper Sensor Test” on
page 26 to check the end-of-forms sen-
sor.
4 Feed Arm Assembly Check all parts of the feed arm assem-
bly for binds, wear, or damage.
5 Software Setting Use Toolkit, on the setup diskette, to
adjust the Top of Form setting.
6 Operator Panel Go to the “ Note: if the failure remains,
replace the system board” on page 12 .