Lexmark 4076-0XX - Manual (Page 35)

4076-0XX
Diagnostic Information 23
5 Print Head Cable Be sure connector J1 is fully seated.
Check the cable for damage.
6 Encoder Strip
Print Head Cable,
System Board Perform the “Encoder Sensor Test” on
page 27 . If you cannot enter the test,
replace the system board.
7 Maintenance Station A problem with the maintenance sta-
tion can cause carrier movement
problems at the right margin. Go to
the
“Maintenance Station Service
Check” on page 12 .
FRU OR PROCEDURE ACTION