Removing an ethernet adapter, Removing, Ethernet – Lenovo 3797 User Manual
Page 64: Adapter
2.
Connect
any
required
cables
to
the
adapter
(see
Attention:
v
When
you
route
cables,
do
not
block
any
connectors
or
the
ventilated
space
around
any
of
the
fans.
v
Make
sure
that
cables
are
not
routed
on
top
of
components
under
the
PCI
riser-card
assembly.
v
Make
sure
that
cables
are
not
pinched
by
the
server
components.
3.
Align
the
PCI
riser-card
assembly
with
the
selected
PCI
connector
on
the
system
board:
v
PCI-riser
connector
1:
Carefully
fit
the
two
alignment
slots
on
the
side
of
the
assembly
onto
the
two
alignment
brackets
on
the
side
of
the
chassis;
align
the
rear
of
the
assembly
with
the
guides
on
the
rear
of
the
server.
v
PCI-riser
connector
2:
Carefully
align
the
bottom
edge
(the
contact
edge)
of
the
riser-card
assembly
with
the
riser-card
connector
on
the
system
board;
align
the
rear
of
the
assembly
with
the
guides
on
the
rear
of
the
server.
4.
Press
down
on
the
assembly.
Make
sure
that
the
riser-card
assembly
is
fully
seated
in
the
riser-card
connector
on
the
system
board.
5.
Perform
any
configuration
tasks
that
are
required
for
the
adapter.
6.
Install
the
server
cover
(see
7.
Slide
the
server
into
the
rack.
8.
Reconnect
the
external
cables;
then,
reconnect
the
power
cords
and
turn
on
the
peripheral
devices
and
the
server.
Removing
an
Ethernet
adapter
To
remove
an
Ethernet
adapter,
complete
the
following
steps:
1.
Read
the
safety
information
that
begins
on
page
and
2.
Turn
off
the
server
and
peripheral
devices
and
disconnect
all
power
cords
and
external
cables.
3.
Remove
the
cover
(see
4.
Remove
the
PCI
riser
card
1.
5.
Push
the
tabs
on
the
adapter
bracket
2
outwards,
then
lift
the
front
end
of
the
adapter
1
to
disconnect
it
from
the
system
board.
Then
lift
it
out
of
the
server.
6.
Install
the
cover.
48
ThinkServer
RD220
Types
3729,
3779,
3797,
and
3798:
Installation
and
User
Guide