Lexmark 5025 - Manual (Page 73)

Universal Setup menu
Menu item Description
Units of Measure
Inches
Millimeters
Identifies the units of measure
Notes:
• Inches is the US factory default setting.
• Millimeters is the international factory default setting.
Portrait Width
3–14.17 inches
76–360 mm
Sets the portrait width
Notes:
• If the width exceeds the maximum, then the printer uses the maximum
width allowed.
• 8.5 inches is the US factory default setting. Inches can be increased in
0.01-inch increments.
• 216 mm is the international factory default setting. Millimeters can be
increased in 1-mm increments.
Portrait Height
3–14.17 inches
76–360 mm
Sets the portrait height
Notes:
• If the height exceeds the maximum, then the printer uses the
maximum height allowed.
• 14 inches is the US factory default setting. Inches can be increased in
0.01-inch increments.
• 356 mm is the international factory default setting. Millimeters can be
increased in 1-mm increments.
Feed Direction
Short Edge
Long Edge
Specifies the feed direction
Notes:
• Short Edge is the factory default setting.
• Long Edge appears only if the longest edge is shorter than the
maximum length supported in the tray.
Reports
Menu Settings Page menu
Menu item Description
Menu Settings Page Prints a report containing information about paper loaded into trays, installed
memory, the total page count, alarms, timeouts, the printer control panel
language, the TCP/IP address, the status of supplies, the status of the network
connection, and other information
Note: The page prints when this item is selected.
Understanding printer menus
73