Lexmark Z2400 Series - Manual (Page 33)

Load up to Make sure
25 greeting cards
25 index cards
25 photo cards
25 postcards
• The total thickness of the card stack does not exceed 10 mm
(0.4 inches).
• The print side of the cards faces you.
• The cards are loaded against the right side of the paper support.
• The paper guide rests against the left edge of the cards.
10 envelopes • The stamp location is in the upper left corner.
• The print side of the envelopes faces you.
• The envelopes are designed for use with inkjet printers.
• The envelopes are loaded against the right side of the paper support.
• The paper guide rests against the left edge of the envelopes.
Warning—Potential Damage: Do not use envelopes that have metal
clasps, string ties, or metal folding bars.
Notes:
– Do not load envelopes with holes, perforations, cutouts, or deep
embossing.
– Do not use envelopes that have exposed flap adhesive.
25 sheets of labels • You follow the loading instructions that came with the labels.
• The print side of the labels faces you.
• The adhesive on the labels does not extend to within 1 mm of the
edge of the label sheet.
• You use full label sheets. Partial sheets (with areas exposed by missing
labels) may cause labels to peel off during printing, resulting in a paper
jam.
• The label sheets are loaded against the right side of the paper support.
• The paper guide rests against the left edge of the label sheets.
25 transparencies • The rough side of the transparencies faces you.
• You don't use transparencies with paper backing sheets.
• The transparencies are loaded against the right side of the paper
support.
• The paper guide rests against the left edge of the transparencies.
Note: Transparencies require more drying time. Remove each
transparency as it exits, and allow it to dry to avoid ink smudging.
33