Land Pride RCR1572 - Manual (Page 18)

16
Section 3: Operating Instructions
RCR1542, RCR1548, RCR1560 and RCR1572 Rotary Cutters 312-556M 12/28/05
Land Pride
Table of Contents
Cutter Height Adjustment
Refer to Figure 3-3:
1.
If the cutting height is too high or too low, the gauge
wheel must be adjusted as follows:
e. Use the tractor’s 3-point hydraulic control to lift the
cutter such that the gauge wheel clears the
ground.
f. Remove the existing hardware; 3/8” -16 x 1" long
carriage bolt (#1) and 3/8” flange nut (#2).
g. Adjust the gauge wheel up or down to the desired
cutting height and replace the hardware.
16391
3-Point Cutter Height Adjustment
Figure 3-3