Palm 755P - Manual (Page 20)

S E T T I N G U P
M A K I N G Y O U R F I R S T C A L L 20
1
CH
AP
T
E
R
1 Press Phone .
2 If prompted, press Center to turn
off Keyguard (see Locking your keyboard
(Keyguard) for more info).
3 If you haven’t already activated your phone,
follow these steps before continuing:
•
Tap the onscreen Dial Pad to enter *228.
•
Press Send to dial.
• When prompted, press 1 (this number
appears on the E letter key) to
program your phone. A service
provisioning message appears on
your smartphone screen.
•
Wait a few minutes until you see the
Programming Successful! message,
and then tap the onscreen OK button.
If the Ringer switch is set to Sound
On
, you hear three tones when
programming is successful.
• Press Power/End to end the call.
4 Tap the onscreen Dial Pad to enter the
number you want to call.
5 Press Send to dial.
6 After you finish the call, press Power/
End to end the call.
Adjusting call volume
While a call is in progress, press the
Volume button on the side of your
smartphone to adjust the call volume.
• To increase the volume, press the upper
half of the Volume button.
• To decrease the volume, press the
lower half of the Volume button.
TIP
You can also dial phone numbers with the
number pad on the keyboard. See Dialing
using the keyboard for details.