Pioneer VSX-919AH-K - Manual (Page 13)

Controls and displays 02
13
En
Press first to access:
PHASE CTRL – Press to switch on/off
Phase Control (page 59).
STATUS – Press to check selected receiver
settings (page 71).
9 AUDIO – Changes the audio or channel on
DVD discs.
DISPLAY – Switches between named
station presets and radio frequencies.
CH +/– – Use to select channels for DVD/
DVR units.
10 REMOTE SETUP – Use to input the preset
code when making remote control settings
and to set the remote control mode
(page 73).
TV CTRL – Use this button to set preset
code of your TV’s manufacturer when
controlling TV (see
Selecting preset codes
directly on page 73 for more on this).
11 MULTI-ZONE operation selector switch
Switch to perform operations in the main zone
and sub zone (page 70).
12 Remote control LED
Lights when a command is sent from the
remote control (page 73).
13  SOURCE
Press to turn on/off other components
connected to the receiver (see page 73 for
more on this).
14 MASTER VOLUME +/–
Use to set the listening volume.
15 MUTE
Mutes the sound or restores the sound if it has
been muted (adjusting the volume also
restores the sound).
16
Switches the remote to control the receiver
(used to select the white commands above the
number buttons (
A.ATT, etc.)). Also use this
button to set up surround sound.
Operating range of remote control
unit
The remote control may not work properly if:
• There are obstacles between the remote
control and the receiver’s remote sensor.
• Direct sunlight or fluorescent light is
shining onto the remote sensor.
• The receiver is located near a device that is
emitting infrared rays.
• The receiver is operated simultaneously
with another infrared remote control unit.
RECEIVER
RECEIVER
7 m (23 ft.)
30°
30°
VSX-1019_KU.book Page 13 Thursday, January 8, 2009 12:01 PM