Pioneer VSX-919AH-K - Manual (Page 70)

Using other functions 08
70
En
4 Use the MASTER VOLUME dial to adjust
the volume for the sub zone.
This is only possible if you selected the
Variable volume control in ZONE Audio Setup
on page 99.
1
5 When you’re finished, press MULTI-ZONE
CONTROL again to return to the main zone
controls.
You can also press the
MULTI-ZONE ON/OFF
button on the front panel to switch off all
output to the sub zone.
2
MULTI-ZONE remote controls
Set the MULTI-ZONE operation switch to ZONE 2
to operate the corresponding zone.
The following table shows the possible MULTI-
ZONE remote controls:
Making an audio or a video
recording
You can make an audio or a video recording
from the built-in tuner, or from an audio or
video source connected to the receiver (such
as a CD player or TV).
3
Keep in mind you can’t make a digital
recording from an analog source or vice-versa,
so make sure the components you are
recording to/from are hooked up in the same
way (see
Connecting your equipment on
page 14 for more on connections).
Since the video converter is not available when
making recordings (from the video
OUT jacks)
make sure to use the same type of video cable
for connecting your recorder as you used to
connect your video source (the one you want to
record) to this receiver. For example, you must
connect your recorder using Component video
if your source has also been connected using
Component video.
For more information about video connections,
see
Connecting a HDD/DVD recorder, VCR and
other video sources on page 28.
1 Select the source you want to record.
Use the input function buttons (or INPUT
SELECT).
• If necessary, press , then press
SIGNAL SEL to select the input signal
corresponding to the source component
(see
Choosing the input signal on page 58
for more on this).
2 Prepare the source you want to record.
Tune to the radio station, load the CD, video,
DVD etc.
Note
1 The volume levels of the main and sub zone are independent.
2 • You won’t be able to switch the main zone off completely unless you’ve switched off the MULTI-ZONE control first.
• If you don’t plan to use the MULTI-ZONE feature for a while, turn off the power in both the sub and main rooms so
that this receiver is in standby.
Button What it does
 Switches on/off power in the sub
zone.
INPUT
SELECT Use to select the input function in
the sub zone.
Input
function
buttons Use to select the input function
directly (this may not work for some
functions) in the sub zone.
MASTER
VOLUME
+/– Use to set the listening volume in the
sub zone.
3 • The receiver’s volume, Audio parameters (the tone controls, for example), and surround effects have no effect on
the recorded signal.
• Some digital sources are copy-protected, and can only be recorded in analog.
• Some video sources are copy-protected. These cannot be recorded.
RECEIVER
VSX-1019_KU.book Page 70 Thursday, January 8, 2009 12:01 PM