Pioneer VSX-919AH-K - Manual (Page 84)

The Advanced MCACC menu 10
84
En
1 Select ‘Fine SP Distance’ from the
Manual MCACC setup menu.
2 Adjust the distance of the left channel
from the listening position.
3 Select each channel in turn and adjust the
distance as necessary.
Use
/ to adjust the delay of the speaker
you selected to match the reference speaker.
The delay is measured in terms of speaker
distance from
0’00-1/2’’ to 45’00’’.
Listen to the reference speaker and use it to
measure the target channel. From the listening
position, face the two speakers with your arms
outstretched pointing at each speaker. Try to
make the two tones sound as if they are
arriving simultaneously at a position slightly in
front of you and between your arm span.
1
When it sounds like the delay settings are
matched up, press
 to confirm and continue
to the next channel.
• For comparison purposes, the reference
speaker will change depending on which
speaker you select.
• If you want to go back and adjust a
channel, simply use
/ to select it.
4 When you’re finished, press RETURN.
You will return to the Manual MCACC setup
menu.
Note
1 • If you can’t seem to achieve this by adjusting the distance setting, you may need to change the angle of your
speakers very slightly.
• For better audibility, the subwoofer emits a continuous test tone (oscillating pulses are heard from your other
speakers). Note that it may be difficult to compare this tone with the other speakers in your setup (depending on the
low frequency response of the reference speaker).
1. Fine Channel Level
2. Fine SP Distance
3. Standing Wave
1c.Manual MCACC
4. EQ Adjust
5. EQ Professional
A/V RECEIVER
Exit Return
A/V RECEIVER
Exit Cancel
MCACC : M1.MEMORY 1
Reference Ch : L
1c2.Fine SP Distance
Ref.Ch Distance : 10’00”
A/V RECEIVER
Exit Finish
R <=> L
L : 10’10”
1c2.Fine SP Distance
R : 9’10”
C : 10’10”
SR : 9’00”
SL : 9’00”
SBL : 6’00”
SBR : 6’00”
SW : 12’10”
VSX-1019_KU.book Page 84 Thursday, January 8, 2009 12:01 PM