Panasonic RX-EX1 - Manual (Page 13)

RQT5671
13
Listening
FM AM
FADER SLEEP
ALL
EQ ON
MONO
ST -REC 1
RANDOM
1 REC
PGM
ST
FADER SLEEP
ALL
EQ ON
MONO
-REC 1
RANDOM
1 REC
PGM
FADER SLEEP
ALL
EQ ON
MONO
-REC 1
RANDOM
1 REC
PGM
FADER SLEEP
ALL
EQ ON
MONO
-REC 1
RANDOM
1 REC
PGM
ST
SLEEP FADER
ALL
EQ ON
-REC 1
RANDOM
1 REC
PGM
SLEEP FADER
ALL
EQ ON
MONO
-REC 1
RANDOM
1 REC
PGM
SLEEP FADER
ALL
EQ ON
MONO
-REC 1
RANDOM
1 REC
PGM
ST
ST
MONO
Auto
scan
C-RESET FM MODE BP
CD PLAY
MODE AUTO SCAN
CLOCK
TIMER TUNER TAPE CD
4 5 6
7 9 0 8
10
P
The Radio: manual tuning
Press [POWER, ] to turn the unit on.
Press [TUNER BAND] to select FM or AM.
Each time the button is pressed: AM FM
Press [TUNE MODE] to select the manual tun-
ing mode.
Make sure that “ ” is not displayed.
Press [REW/–/ ] or [ /+/FF] to select a
station.
“ ” is displayed during FM stereo broadcasts.
Turn [– " " " " " VOLUME # # # # # +] to adjust the volume.
Auto-tuning
Press and hold [REW/–/ ] or [ /+/FF] until the fre-
quency starts changing rapidly.
Stops when it finds a station. (Interference may also cause
it to stop. Start auto-tuning again if this occurs.)
To stop auto-tuning
Press [REW/–/
] or [ /+/FF].
Using auto scan
Remote control only
You can search for a station by listening to all tuned-in
stations for 8 seconds each.
■
1 Press [TUNER] to select “FM” or “AM”.
■
2 Press [AUTO SCAN].
Auto scan starts.
■
3 Press [AUTO SCAN] when you find the de-
sired station.
Auto scan ends when it reaches the original frequency again.
To stop during the process, press [AUTO SCAN].
To improve reception
FM: Change the length and position of the antenna.
AM: Change the facing of the unit.
•AM reception is briefly interrupted if a tape deck is operated.
•To improve reception when using the unit in a building or
vehicle use it near a window.
If noise is excessive in FM
Remote control only
Press [FM MODE/BP] to display “ MONO ”.
Monaural sound is selected (“ ” goes off) and noise re-
duces when reception is weak.
Press [FM MODE/BP] again to cancel the mode.
To receive FM broadcasts allocated in 0.1MHz
Main unit only
First press [TUNER BAND] to select “AM”. Now, press and
hold [TUNER BAND]. The display changes in a few sec-
onds to show the current lowest FM frequency. Continue to
hold down the button.
The minimum frequency changes and the step is changed at
the same time. Changing the step erases all preset stations.
Repeat the above to change the step back.
re-ex1(p10-p15)[P] 00.12.28, 4:58 PM 13