Panasonic RX-EX1 - Manual (Page 15)

RQT5671
15
Listening
Recording
PGM
ALL
RANDOM
1
EQ ON
MONO
ST -REC 1
SLEEP PLAY
REC
FADER RE
PGM
ALL
RANDOM
1
EQ ON
MONO
ST -REC 1
SLEEP PLAY
REC
FADER RE
ALL
RANDOM
1 - 1
SLEEP PLAY FADER RE
PGM
EQ ON
MONO
ST REC REC
ALL
RANDOM
1 - 1
SLEEP PLAY FADER RE
PGM
EQ ON
MONO
ST REC REC
ALL
RANDOM
1 - 1
SLEEP PLAY FADER RE
PGM
EQ ON
MONO
ST REC REC
Present state (e.g., elapsed play time of CD)
Present time
Tape counter
Tape Counter Tape Playing
Cassettes
Press [POWER, ] to turn the unit on.
Insert a cassette into the deck.
Play starts from the side facing up.
Press [ 3 TAPE] to start play.
Turn [– " " " " " VOLUME # # # # # + ] to adjust the volume.
To stop play
Press [
7
TAPE/CD].
To eject tape
Stop tape play, then press [
0
TAPE].
One touch play (When using AC power)
When a cassette is loaded, press [
3
TAPE].
The unit comes on and play starts.
Fast-forward and rewind
Press [REW/–/ ] (rewind) or [ /+/FF] (fast-forward).
Selection of tapes
Use normal position tapes to play correctly.
High position and metal position tapes can be played, but
the unit will not be able to do full justice to the characteristics
of these tapes.
Cassette tape care
• Tapes exceeding 100 minutes are thin and can break or
get caught in the mechanism.
• Tape slack can get caught up in the mechanism and should
be taken up before the tape is played.
• Endless tapes can get caught up in the deck’s moving parts
if used incorrectly.
Before Recording
Use household AC power or new batteries when recording,
to avoid poor recording caused by the batteries running down.
Television can cause interference to recording made on this
unit if the two are too close to each others.
Selection of tapes for recording
Use normal position tapes.
High position and metal position tapes can be used, but
the unit will not be able to record or erase them correctly.
Volume and sound quality in recording
• Recording level is set automatically.
• Recording are unaffected by changes to sound quality.
To display the tape counter while
recording
Remote control only
Press [DISPLAY].
Each time you press the button in the CD or radio mode:
To reset the tape counter
Press [C-RESET].
The counter resets to “000”.
re-ex1(p10-p15)[P] 00.12.28, 4:58 PM 15