Panasonic WJ-RT208 - Manual (Page 29)

29
(3) Move the cursor to "PTZ SELECT" and press the [SET]
button.
Move the cursor to the desired channel by using the
direction buttons (up/down). Select the channel by
using the direction buttons (right/left).
In the above figure, "Cam1" is selected in the "PTZ
SELECT" menu. No other camera are selected in other
channels.
(4) Press the [MENU] button. "WJ-RT208 SETUP MENU"
appears. Refer to step (1).
(5) Move the cursor to "CAMERA SETUP" and press the
[SET] button.
The "CAMERA SETUP" menu appears. Select "PTZ
Protocol".
When using the Panasonic’s camera, select "PANA-
SONIC" using the direction buttons (left/right).
In other cases, refer to the relevant instruction manual
for that camera.
(6) Press the [MENU] button. "WJ-RT208 SETUP MENU"
appears. Refer to step (1).
(7) Move the cursor to "COMMUNICATION SETUP" and
press the [SET] button. Then move the cursor to "RS485
SETUP" and press the [SET] button.
Note: When the Panasonic's camera is used, make set-
tings of the respective parameters according to the
above-mentioned procedures. In other cases, refer
to the relevant operating instructions.
Caution: In order to maintain normal communication
between this unit and the cameras, it is necessary
to have completely correct settings for "PTZ
SELECT", "PTZ Protocol", and "RS485 SETUP".
The camera control mode comes in three types.
Each time the [SET] button is pressed in the state of
monitoring, the mode changes. The related icon is
displayed in a lower area of the screen.
• Pan/tilt control mode
• Zoom/focus mode
• Iris control mode
Note: For some types of cameras, some controls
many not function. Refer to the relevant operat-
ing instructions of the camera and confirm
whether this unit is enabled to support controls
and connections.
2.5.1 Panning/Tilting
(1) Select the desired channel by using the direction button
or numeric button. The image frame of the selected
channel blinks.
Select the pan/tilt control mode by pressing the [SET]
button once.
The camera pan/tilt control icon
is displayed on the
screen of the selected channel.
(2) Press the direction button and turn the camera in the
proper direction.
Note:
In the pan/tilt control mode, two external units can
be connected to the cameras.
When the camera select button [1] is pressed,
External Unit 1 is set to ON.
When the camera select button [2] is pressed,
External Unit 2 is set to ON.
When the camera select button [6] is pressed,
External Unit 1 is set to OFF.
When the camera select button [7] is pressed,
External Unit 2 is set to OFF.
(3) Press the [SET] button 3 times to close the pan/tilt con-
trol mode.
2.5.2 Auto function (Auto Pan, etc.)
(1) Select the pan/tilt control mode by pressing the [SET]
button once.
The camera pan/tilt control icon
is displayed on the
screen of the selected channel.
(2) Start the auto function by pressing the [PLAY] button.
Note: Refer to the Operating Instructions of the camera
for descriptions of the auto function.
OK
Cam1
Cam5
Cam2
Cam6
Cam3
Cam7
Cam4
Cam8
PTZ SELECT
Cancel
CAMERA SETUP
1 Channel No.
On CH Enable
Set Mask Area
Off Mask Enable
PANASONIC PTZ Protocol
000
All OK Cancel
Rec. Reserve
Channel Name CH1
Days
RS485 SETUP
OK
19200 Baud Rate
Cancel
8 Data Bit
None Parity
1 Stop Bit