Planet Technology DVR-460 - Manual (Page 14)

3.2.2 PTZ camera connection
1) Power connection:
Connect the PTZ camera with indicated power supply.
2) Video cable connection:
Connect the PTZ camera video output to the DVR video input with a coaxial cable / RCA
line and BNC connector.
3) RS485-A & RS485-B wires connection:
Solder the RS485-A (brown) and RS485-B (orange) wires of the PTZ camera to the
corresponding pins on the solder side of the 15 PIN D-Sub connector (see the figure
below). To protect the naked wires, use the insulation tape to cover on the twisted wires.
PTZ Camera –
RS485-A and RS485-B wires of the PTZ camera
For 4CH DVR –
15 PIN D-Sub Connector
RS485-A: Brown wire RS485-A: PIN 11
RS485-B: Orange wire RS485-B: PIN 10
Solder Side of
15-pin D-Sub connector
RS485-A: PIN11; RS485-B: PIN10
1
9 12 13 14 15
16 17
2 3 4 5 6 7 8
10 11
4) Camera Setup:
For detailed camera title, ID, protocol and baud rate setup, please refer to “7.3
REMOTE”.
DVR-460 User Guide 14