Panasonic BL-PA300A - Manual (Page 17)

17 [For assistance, please call: 1-800-272-7033]
Useful Information
Understanding the indicators
PLC Green, lit The adaptor is successfully connected to the
HD-PLC network.
Green, flashing The terminal is being registered to the master.
Green, flashes
once every 5
seconds The adaptor is registered to the master, but it is
not connected to the HD-PLC network.
Red, lit for 5
seconds There was an error during registration. Try
again.
Red, lit The adaptor is not functioning properly and
cannot communicate over the HD-PLC
network. Contact an authorized Panasonic
service center.
Off The adaptor is not plugged in.
The adaptor is not connected to the HD-PLC
network (no other adaptors found, not
configured, etc.).
LAN Green, lit A LAN cable is connected to the adaptor.
Green, flashing Data is being sent/received.
Orange, lit There is no network device connected to the
adaptor via the LAN cable, or the network
device is not turned on.
Off The adaptor is not plugged in.
Power Save is active. (See page 13)
MASTER Green, lit The adaptor is configured as the master.
Green, flashes
for 10 seconds A terminal has been successfully registered to
the master.
Off The adaptor is not configured as the master.
BL-PA300A_OI.book Page 17 Wednesday, August 6, 2008 9:59 AM