Paxar 545 - Manual (Page 48)

46 • Control Panel Operation Users Manual Model 545™
P R I N T P O S I T I O N S T A T I O N 2
V A L U E : ± X X N E W V A L U E : ± Y Y
This screen follows the "PRINT POSITION STATION 1" screen. This screen
allows the print position of station 2 to be adjusted in the feed direction.
The <YES / NO> buttons are used to change the new print position value. The value
is displayed in a positive / negative format. The value ranges for XX and YY can be
from a -99 to a +99. Pressing ENTER will change the VALUE to the NEW
VALUE. A more positive number will move the print of station 2 to the right while
a more negative number will it to the left.
Pressing the MODE / Down Arrow key will take the user to the "PRINT OFFSET
STATION 1" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.
P R I N T O F F S E T S T A T I O N 1
V A L U E : ± X X N E W V A L U E : ± Y Y
This screen follows the "PRINT POSITION STATION 2" screen. This screen
allows the offset print position of station 1 to be adjusted.
The <YES / NO> buttons are used to change the new print offset value. The value is
displayed in a positive / negative format. The value ranges for XX and YY can be
from a -20 to a +20. Pressing ENTER will change the VALUE to the NEW
VALUE. A more positive number will move the outboard half of the image printed
by station 1 to the right while a more negative number will move it to the left.
Pressing the MODE / Down Arrow key will take the user to the "PRINT OFFSET
STATION 2" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.
P R I N T O F F S E T S T A T I O N 2
V A L U E : ± X X N E W V A L U E : ± Y Y
This screen follows the "PRINT OFFSET STATION 1" screen. This screen allows
the offset print position of station 2 to be adjusted.
The <YES / NO> buttons are used to change the new print offset value. The value is
displayed in a positive / negative format. The value ranges for XX and YY can be
from a -20 to a +20. Pressing ENTER will change the VALUE to the NEW
VALUE. A more positive number will move the outboard half of the image printed
by station 2 to the right while a more negative number will move it to the left.
Pressing the MODE / Down Arrow key will take the user to the "CHANGE CUT
POSITION" screen. Pressing the EXIT / Up Arrow key will take the user back to
the "HOME" screen.