Paxar 545 - Manual (Page 61)

Users Manual Model 545™ Maintenance • 59
Manual Manifold Seal Cleaning
CAUTION: The print head nozzle plates are very delicate, use extreme
care not to contact the print head nozzle plates while the print
heads are in the print position. Use nothing other than foam
tips with minimal pressure while cleaning the manifold seals.
From time to time depending on the amount of dust and debris in the printing
environment the manifold seals may need to be cleaned by wiping. This will
maintain the module’s ability to form a seal between the print heads and the
manifold. Use the following procedure to position the print module swing arms to
the print position for cleaning purposes, and then back to the parked position when
done.
Positioning Swing Arms for Seal Cleaning
• Go to the PRINT HEAD CLEANING PROC menu on the front panel
and press "enter".
• From either of the first two sub menu items:
(PRESS ENTER FOR / CLEANING STATION 1 (or 2)).
• Press the “YES (←)” button to swing the (active) print station(s) to the
print position.