Paxar 545 - Manual (Page 71)

Users Manual Model 545™ Electrical Trouble Shooting • 69
Fabric Advance
Problem Probable Cause Corrective Action
Fabric does not advance
when the start button is
depressed.
1) No batches to be printed. 1) Download batch (if batch downloaded uses the
same format as a previously downloaded batch
the printer with start automatically).
2) An interlock condition exists. 1) Determine the number and type of interlock(s)
by reading the front panel display. As each is
corrected the number of errors will decrease
(Example "Error 910 Feed Open" close feed).
3) Feed roller(s) not gripping the
fabric.
1) Clean the feed rollers in the active unwind and
the feed module.
4) Feed rollers bound. 1) With power off - check that all rollers turn
freely.
5) Fabric bound. 1) With the feed open and the pressure roller held
open in the active unwind - check that the
fabric will pull through the printer with little to
no resistance.
6) Feed motor(s) unplugged or
faulty.
1) Check the feed motor cable(s) and or replace
the active unwind or feed motor.
7) Thermal Control Board
unplugged or faulty.
1) Check Thermal Control Board / AT board
connection and or replace Thermal Control
Board.
8) Finishing Interface Board
unplugged or faulty.
1) Check Finishing Interface Board connections
and or replace Finishing Interface Board.