Panasonic DBS 824 - Manual (Page 135)

Line Appearances Key Telephone Features
3-48 DBS 824-3.0/3.2-700 Revised April 2000
DSS/BLF Appearances
(CPC-S and CPC-M)
Description
When a DSS/BLF key is programmed, it automatically provides direct station
selection and busy lamp field for the assigned extension number. If desired,
the DSS/BLF key can also provide ring monitor.
For example, you can set extension A as a DSS/BLF key on extension B.
When extension A rings, the LED of the DSS/BLF key on extension B
flashes. If extension B answers the call by pressing the DSS/BLF key, the
LED on extension A goes off and the call remains only on the DSS/BLF key
of extension B.
Ringing can be set on either one or both extensions. If the extensions are not
set for ringing, the LED of the DSS/BLF key will flash red. If the extensions
are set for ringing, the LED will flash green.
When extension A is in use, the LED of the DSS/BLF key on extension B will
light red. If one extension has the Absence Message, Call Forwarding, or Do-
Not-Disturb feature activated, the DSS/BLF key will light green.
Operation
To assign a DSS/BLF key:
1. Press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key to be assigned the DSS/BLF appearance.
4. Dial the extension number.
5. Press HOLD key.
6. Press the ON/OFF key.
To make an intercom call using the DSS/BLF key:
Press the idle DSS/BLF key.