Panasonic WV-NP472 - Manual (Page 41)

-41-
Transparency: Indicates a non-masked area that
has been incorporated into the detection area.
Blink: Indicates a non-masked area when the cur-
sor is on it.
Highlight: Indicates a masked area that has been
exempted from detection.
Stripe: Indicates an area already set to masked
when the cursor is on it.
6. Move the cursor to an area, and click ENTER.
• The area will change from blinking to highlighted
(masked), and then to striping.
• The striping area will change to blinking (non-
masked).
7. Repeat step 6 until all areas are set.
8. Click the ESC button to return to the ** MOTION
DETECT ** menu.
9. VMD demonstration
• To confirm the alarm output function, move the
cursor to ALARM, and turn it to ON.
• Move the cursor to DISPLAY MODE
O, and
click ENTER.
The demonstration starts, and the areas will
blink where motion is detected.
Blinking
• Click ENTER to return to the ** MOTION
DETECT ** menu.
10. Move the cursor to Level, and adjust the detection
level, moving the "I" cursor with the right or left but-
ton.
11. Repeat step 9 and step 10 to obtain a proper level
setting.
12. To return to ** CAM SETUP **, move the cursor to
RET, and click ENTER.
To return to the main page, click the Menu OFF
button, then the Return button.
■ Reviewing Alarm Pictures
The alarm pictures stored in the camera can be
reviewed on the PC.
1. In the main page, click the Alarm List button.
2. Click the desired event in the list.
The events can be stored in chronological order
from 1 up to 100, and the oldest event will be
erased when the new one is added.
The event followed by an icon contains picture
file(s).