Philips MAGIC 5 ECO PPF 695 - Manual (Page 51)

Service 51
EN
Copy is blank. Insert the documents face up into the document feeder.
Printing is interrupted. Paper or document jam, no paper or ink film. Follow the
instructions on the display and in the error report.
There could be a small pause after printing several pages.
The device continues printing automatically.
No printing Check if you have inserted clamped paper correctly. The
lever on the right hand side next to the paper feeder must
be folded backwards.
Documents are not properly fed. Clean the scanner and the document feed slot.
Problems when faxing or printing
Problems with the connection
The device rings once, remains silent for a short while and
starts ringing again. This is absolutely normal. The fax switch checks the call af-
ter the first ring. If it is a voice call, the device continues to
ring.
No dial tone Check the installation of the device. Connect the telephone
cable to the socket marked
LINE. Insert the telephone plug
into your telephone connection socket.
Fax transmissions are constantly interrupted. Try to send the fax manually: Press
ß and dial the number.
If the recipient is using an answering machine, wait until
you hear a whistling tone. Press
START.
It is possible that the recipient's machine is not ready to re-
ceive.
You hear a whistling tone or silence in the handset. The call is a fax: Press
START on the device. In addition,
press
*5 on the telephone. Hang up.
No fax reception or a short fax audio signal as message on
the answering machine Using function 51, set the number of rings for the fax
switch to 4 and the total number or the number of rings for
the answering machine (model dependent) to 5 (see Page
38).
You cannot simultaneously use the answering machine fa-
cility of your telephone service provider (= voice-mail box)
and receive faxes on your devices(see page 43).
Problems with the Cordless Telephone
Cordless telephone does not function or does not function
as expected.
Display shows only the battery charge. Check if the cordless telephone is functioning and is regis-
tered with the device.
Switch the cordless telephone off. Open the battery com-
partment on the backside. Remove the batteries and insert
them again. Close the battery compartment and switch the
cordless telephone on again.
No dial tone The cordless telephone is not registered with the device or
is out of range.
The cordless telephone cannot be switched on. Place the cordless telephone into the charging station.
The cordless telephone cannot be switched on after 12
hours in the charging station. Change the batteries in the cordless telephone (also see
Chapter Service, Page 49).