Panasonic JOIP BB-GT1540E User Manual
Page 71
Intercom Features
71
For product assistance, visit www.globarange.com
For A assistance, visit www.joip.com
Note:
L
You can locate a misplaced handset
by paging it.
BB-GT1540
1
{x}
2
To page a specific handset, enter its
extension number ({1} – {6}).
To page all handsets, press {0} or
wait for a few seconds.
L
The paged handset(s) beeps for 1
minute.
L
To stop paging, press {x}.
3
When you finish talking, press {x}.
Note:
L
You can locate a misplaced handset
by paging it.
Answering an intercom call
1
Press ] to answer the page.
2
When you finish talking, press {i}.
1
Press {x} to answer the page.
2
When you finish talking, press {x}.
Note for handset and base unit:
L
The ringer volume for intercom calls
follows the higher volume level of the
2 lines (page 52, 59).
L
When the ringer volume is set to off for
both lines, the handset or base unit
rings at a low level for intercom calls.
Answering an intercom call using
auto intercom
Before using the auto intercom, turn auto
intercom on (page 69).
1
When you are paged by the base
unit, speak into the microphone.
L
To switch to the receiver, press
{s}
.
2
To end the intercom, press {i}.
Monitoring audio in a room using
auto intercom (BB-GT1540)
You can listen to the sound in a room
where the handset is located using the
auto intercom (page 69).
Important:
L
Before using this feature, set auto
intercom on the destination handset to
“On (Ringer Off)” to allow access
by the base unit (page 69).
1
Call the destination handset (page
71).
L
You can listen to the audio.
2
To mute your sound output, press
{T}
if necessary.
3
Press {x} to stop monitoring.
Transferring calls, conference
calls (BB-GT1540)
Outside calls can be transferred
between the handset and base unit. The
handset and base unit can have a
conference call with an outside party.
1
During an outside call, press {INT}
to put the call on hold.
2
To page the base unit, press {0}.
3
Wait for the paged party to answer.
L
If the paged party does not
answer, press {TEL} or {IP} to
return to the outside call.
4
To complete the transfer:
Press {i}.
L
The outside call is being routed to
the base unit.
Handset
Base unit
Handset
Base unit
Handset
GT15xxE.book Page 71 Wednesday, August 1, 2007 11:59 AM