Panasonic JOIP BB-GT1540E - Manual (Page 87)

Useful Information
87 For product assistance, visit www.globarange.com
For A assistance, visit www.joip.com
Programmable settings
Battery recharge
The 4 indicator is off. L The power of the base unit is off.
L
You have not agreed to the Terms of Use for
the A services. To use the A IP line, you
need to agree to it using the handset (page
19).
L The Ethernet cable is not connected properly.
Connect it.
L Your network devices (hub, router, etc.) are
turned off. Check the LEDs for the link status
of the devices.
Problem Cause/solution
I cannot program items. L Programming is not possible while either
another handset or the base unit is being
used. Try again later.
L
Programming is not possible while the base
unit is downloading data from the A
service. Wait until the 4 indicator stops
flashing and lights in steady green.
While programming, the
handset starts to ring. L A call is being received. Answer the call and
start again after hanging up.
I cannot register a handset to a
base unit. L The maximum number of handsets (6) are
already registered to the base unit. Cancel
unused handset registrations from the base
unit (page 77).
L You entered the wrong PIN number. If you
forget your PIN, see page 91.
L Place the handset and the base unit away
from other electrical appliances.
Problem Cause/solution
I fully charged the battery, but
3
continues to flash, or 4
is displayed.
L Clean the charge contacts and charge again
(page 21).
L
The battery may need to be replaced with new
ones (page 22).
The handset display is blank. L Confirm that the battery are properly installed.
L
Fully charge the battery (page 21).
Problem Cause/solution
GT15xxE.book Page 87 Wednesday, August 1, 2007 11:59 AM